Archive

Posts Tagged ‘6500c’

Controller type consideration about LCDs

September 12, 2010 Leave a comment

E51?: LCD ACX559AKM-7 (SONY?)- code 4851025 : controller compatible partially with LDS285 (but probably it is not LDS285)
6500c: LCD LS8303164 (SHARP) code 4850198 : more compatible with LDS285 (responding to DISCLK command properly)
E65: LCD LS022Q8UX04 (SHARP) : partial compatibility with LDS285

No one of them have built-in LED driver (no one responded to LEDCTRL command of LDS285)…

UPDATE:
It seems that these LCDs are compatible to this controller : http://hw.cz/files/redaktor130/MC2PA8201pdf.pdf

Advertisements
Categories: LCD, microcontrollers Tags: , , , ,

Using Tearing Line Output from Nokia LCD

September 12, 2010 Leave a comment

Nokia LCDs mentioned in this blog has tearing line output feature. It can be used to synchronize MCU->LCD writes with LCD display memory scan pointer.
What for? To prevent showing partially content we want to write to LCD’s display RAM.

Problems :
A) your MCU should be fast enough to stream whole framebuffer to LCD within TE (Tearing Effect line output) pulse -> then, LCD read pointer won’t start scanning the frame before whole MCU->LCD transfer ends.
OR:
B) your MCU should be fast enough to stream whole framebuffer to LCD between n and n+2 TE pulses -> then LCD read pointer starts before write to LCD display memory occurs and write pointer will be always behind read pointer of LCD’s memory controller.

If your MCU isn’t fast enough to meet these requirements, tearing would always appear…

TE pulse width is given by LCD’s frame refresh rate (default ~60Hz).
At 60Hz frame scan time is about 16ms. Full frame is 320x240x3 bytes = 230400 bytes. To be able to write full framebuffer during two frame scan time (option B) your MCU should have data computation & throughput speed ~7 MB/s…
Well, it is impressive in the world of cheap and easy MCUs, even PIC32s 🙂

Categories: LCD, microcontrollers, PIC32 Tags: , , , , , ,

Using Nokia BB5 LCD with PIC32

September 11, 2010 Leave a comment

Short brief :
source : http://www.elektroda.pl/rtvforum/topic1344700.html
help :
– Leadis reference to LDS285 : http://www.trulydisplays.com/tft/driveric/IC%20Spec%20LDS285.pdf
– Microchip toolz & CPUs
objective : using Nokia’s LCD with Microchips CPUs

Finally, objective achieved 🙂

Findings :
“Modern” BB5 Nokias are using MIPI’s MeSSI bus between MPU and LCD controller.
Although obtaining MeSSI specification from MIPI can be hard for hobbyist, bus is 100% compatible with popular 8080 Interface = Mode2 Parralel Master Port in PIC32… 🙂
LCDs of E51 or E65 are pin-to-pin compatible, many others (BB5-style) has the same pinout and connector.

Pros:
– 320x240x24bit LCDs
– integrated controller with DDRAM (no need to waste MPU RAM for storing display data)
– cheap solution (~8-10$ for a piece of glass)
– simple interface, really 🙂

Cons:
– such LCD require relatively high computational power

more info incoming soon…